6x Directional Push Buttons (5x PL, 1x PS) DIP switches (8x PL) PMBUS & System Controller MSP430 for power, clocks, and I2C bus. Most of the installation process probably did not play into my boot problems but I will quickly go through the steps I took on each installation: 1. Set SW6 to on,off,off,off (SD Card boot mode).
ext4 file into the SD card before I change the SD card format. A Tour of the Pi Zero Making an SD Card – Using Windows. Step 1 Connect the SD card to a Windows computer and launch DiskGenius. NOTE: - SD Card Auto Launch Script should have same IP address as configured in UI’s. Use Win32 Disk Imager to write an IMG file to a USB drive or SD card. Configure Boot Mode To boot from SD card the boot mode pins have to be configured accordingly, as shown in the image below.
